Our 2,700 square foot machining department
consist of 7 horizontal mills and 4 lathes. In
this department we manufacture everything
from small components for Hitachi Kokusai
pan tilts to the heat sinks for our line of ultra
bright monitors.

Sheet Metal

The sheet metal department consists
of two large press punches that have the
capability of running around the clock.
The Trumpf trumatic 20-20 punches
sheet metal at a speed of 900 hits per
minute with a force of 22 tons. For smaller
jobs, the water jet is the perfect tool for
cutting steel of to six inches deep with a
bed that spans ten by five feet. This
department also boasts 2 Amada press
brakes that can bend spans up six feet.
Hardware insertion takes place in this
department with a total of two stations.


Display Devices certified welding staff has over 40 years of combined welding
experience. Our three bays consists of both TIG and MIG welders, so depending
on the need, there is less setup time.